2001 Toyota Avalon "oil clock" Questions

...clock display and fuel/oil/high beam indicators Hi I have a 1998 srad 600 my clocks have half stopped working, Speedo and rev counter working but when bridged wire from one bulb over to get a second ...

...behind. there is a button located on the end of the turn signal that controls the clock function on the dash and the radio clock. After oil chang how do i reset the clock on my 2001 BMW 325i

...oil change. and how to activate the clock after i changed the battery (the clock does'nt show the number only dash after i changed the battery). WHILE HOLDING LEFT ODOMETER RESET BUTTON TURN KEY TO ...

...gear mark lines up with head at 9 o clock and dowl pin near centre bolt is at 12 o clock crank gear keyway at 12 o clock and mark in disc behind gear lines up with mark on oil pump at 12 o clock

...clock 14yrs old oil pressure indicates4 to quart 108k on clock 14yrs old oil pressure indicates drop from 4 to just over quarter when warm xj6 gold 3.6 when driving pressure remains below 4,when i ...

...oil to flow. Hold the can up-right call that 12 o-clock . After a few seconds rotate the can to the 3 o-clock possition for two to three sec. then rotae back to 12 o-clock. Reapeat this every few ...

clock DO NOT DRIVE until repaired/checked....Check your oil level, if ok have the vehicle checked possible oil pump failure or clogged oil ports. If your oil is low/empty have your vehicle checked for

clock up the miles quickly then extend the oil changes to 6,000miles /10,000km Oil filter is every second oil change. Use reputable multi grade oil 15W/40 or similar, Do not use standard SAE 30 single

...Oil level a bit high. What's wrong? 53000 miles on clock been sounding good Likely head gasket failure. Oil level appears high because coolant is leaking into oil. This dilutes the oil causing the ...

Oil drain plug to open is anti clock wise how too loosen engine oil drain plug I don't think I have seen an oil drain plug that is left hand threaded, it may have been put in wrong and your thread is ...