Hyundai Motor 2003 Elantra "pillar switch" Questions

all 4 windows to stop working? Wiggle the wires going into the door from the pillar where the door hinges are while trying to put the window up or down if nothing happens then change the master switch

...switch, it's shorting out. It's on the B-pillar below your door latch, covered in rubber that you can pull off to get access to it. You can take it out, just tie a string to the electrical connector ...

switch. If so, clean and repair the connector as necessary. Go to step c below. c. For 2006~07 Sonata: Remove the front pillar cover and verify the harness is properly routed near the clip. Repair the

...pillar limit switch if the belt is going all the way back but not shutting off. Unfortunately the rear limit switch is serviced with the track & motor assembly. Get a used one at car-part.com. Page ...

1987 Nissan Maxima fuel pump relay location? Relay is in the right side roof B-Pillar, just above the door pin switch. A-pillar is in front of the door. B-pillar is behind the front door

...switch need to locate drivers side door jamb switch check at the bottom of the pillar just inside where the sealing rubber is on the door or check on the front door pillar near the bottom door

...switch Problem could be broken wires running between pillar post and door. First check the wires on passengers side by pulling back the rubber covering that covers the wires between pillar and door. ...

switch is in the OFF position. Remove the right front hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side . Disconnect the body wiring harness electrical connector

...switch to no avail. I would check the grounds for the BODY SECURITY MODULE. I think it is near the back of the cab, behind the driver. There is one ground on the cab panel and the other is on the ...

...PILLAR TRIM - REMOVAL) Remove the sunvisors. (Refer to 23 - BODY/INTERIOR/SUN VISOR - REMOVAL) Remove the overhead console. (Refer to 8 - ELECTRICAL/OVERHEAD CONSOLE - REMOVAL) Disconnect the control ...