...slave cylinder by removing the line and capping it off, and if you have a firm pressure on the clutch pedal ( don;'t try to push it down, just check for pressure!) then your slave cylinder is bad. If ...
...slave cylinder Need to know year and engine size. I know that the 1999 Dakota 2.5L clutch hydraulic system comes as a pre-charged, completely sealed system including the reservoir, master/slave ...
Question about Cars & Trucks
...slave cylinder inside the bell housing of the transmission. This means that the fluid line to the slave cylinder was removed to remove the transmission. If a new slave cylinder was installed when the ...
Question about Jeep Cars & Trucks
...cylinder, slave cylinder and connecting line are serviced as an assembly only. The linkage components cannot be overhauled or serviced separately. The cylinders and connecting line are sealed units. ...
...slave cylinder on 1990 F150 5 speed manual trans. and bled the lines and now the clutch pedal sticks when the clutch is released quickly. Everything working good before replacing slave cylinder ...
...to pull slave clutch cylinder Remove the transaxle. Remove the hydraulic line from the slave cylinder. Remove the hydraulic line from the slave cylinder. do you have the 2.2 4 cyl or do you have a
...slave cylinder pump the cluth pidal until its become hard just hold then open bleeder screw In this car, there is no bleed port provided. The hydraulic clutch system is closed and is sold only as a ...
...slave cylinder: Removal & InstallationBefore servicing any vehicle, please be sure to read the precautions section, which deals with personal safety, prevention of component damage, and important ...
Question about Cars & Trucks
Do you have to remove engine to change a clutch slave cylinder on a korando 2.0 fwd 2015 Remove the clutch fluid line at the slave cylinder and the holding bolts and remove the cylinder.
2,484 questions posted
Usually answered in minutes!
907 Questions
707 Questions
348 Questions
103 Questions
32 Questions