2002 Jaguar X-Type "remove back seat panel" Questions

...remove the back seat. Not an easy task, but this is the only way. A. remove the plastic kick plate on floor leading to back seat. This will allow you to pull out the padded liner that is not part of ...

...back, the seat and mirrors didn't work\ can you help please? they can't find the problem. we tried the fuzes. thank you. Rosa. Sounds to me like this which is not grounded or they have text the wrong ...

back seat and remove two bolts in the center of each seat back striker plates. Remove two bolts from outboard rear seat back frame retaining brackets. Lift seat back up and pull forward to remove from

...back and remove seat back; Remove the seat belt retractors; Remove the push in retainers from the cross car beam; Lift up on the front of the shelf panel to disengage the hook and loop material; then ...

...back seat remove that lay it down in the back seat. You now have complete access from the rear seat to the trunk. To reassemble reattach rear seat top. Reassemble black panel in trunk just attach to ...

Remove Back Seat: Locate the retainers securing the seat bottom into the vehicle, approximately 10 inches from the end of the cushion, either side. Use your thumb to push in retainer release tab. Lift

back upward and remove.Installation Align the upper hooks with the upper brackets on the back panel of the cab.NOTE: Make sure the safety belt webbing is not twisted. Route the rear center safety belt

...remove rear seat for recovering,of Mitzubishi 4 door 2005 sedan If the seat base is fixed it is usually held down with two or three screws on the underside of the seat pad. It's the upright panel ...

...remove the inside back seat panel; driver's side. Any tips? I did this the other day. I think there were 1 or 2 screws holding it in place that you have to remove the bottom part of the back seat to ...

remove the driver seat back panel 2005 Kia Optima power driver seat Is a special tool needed to remove this panel? Pulling it back I see nylon clips over metal coils. Looks like installation is merely