1994 Geo Prizm "battery negative positive" Questions

...Battery Constant 12v+ Wire: White Car Radio Accessory Switched 12v+ Wire: White/Black Car Radio Ground Wire: Black Car Radio Illumination Wire: Red/Yellow Car Stereo Dimmer Wire: Red/Green Car Stereo ...

...negative lead of the meter to the positive battery cable post and the positive meter lead to the start solenoid stud at the starter. You should not see more than 0.5 volts. If you see more than that, ...

...negative battery terminal on the battery. Loosen the clamp bolt on the negative battery cable end with a wrench and remove the cable from the battery terminal. Isolate the battery cable from the ...

How do you deactivate airbags on 1997 Geo Prizm to install a new Ignition Switch? Disconnect battery, either negative or positive terminal.

...negative cable good to battery neg. post and then put other side on neg cable to engine ground on block. See if it cranks, if it does than the trouble is on the neg. cable. If not then put positive ...

...battery. If it is less than 12 volts, it will not start the engine anyway, so it must be tested and recharged if good, or replaced if bad. Next the positive and negative cables at both ends of them ...

...negative battery end of cable to engine ground, or other end of cable where it bolts onto the engine if you can get to it. Good ground is essential to your recharge circut efficiency. When using the ...

...Battery Constant 12v+ Wire: Red Car Radio Accessory Switched 12v+ Wire: Orange/Yellow Car Radio Ground Wire: Black Car Radio Illumination Wire: Red/Green Car Stereo Dimmer Wire: Green/Red Car Stereo ...

...alternator and your starter so you will need to get under the car.MAKE SURE YOU DISCONNECT THE NEGATIVE SIDE BEFORE DOING ANY WORK AND START AT THE STARTER AND WORK YOUR WAY BACK UP TO THE

...ENGINE FLASHES WILL BE YOUR CODES.TWO FLASHES AND PAUSE THEN THREE MORE FLASHES IS CODE 23.THAT HOW YOU DO IT.TO ERASE CODES AFTER THE REPAIR.REMOVE NEGATIVE BATTERY CABLE FOR 1 MINUTE TO REMOVE