2000 Mercury Sable "remove back seat" Questions

Ad

Question about Mercury Sable

1 Answer

...back seat and remove the 18 mm bolt and remove the seatbelt anchor. To remove the lower back seat pull up sharply on the front left and right sides of seat, only held in with plastic clips, then seat ...

Ad

...Then you should see two more at the bottom of the seat back holding it in . Remove these and lift the back bit straight up off the retaining clips.. take a trip to the wreckers if you are in

Ad

...back. Remove them. Pull the seat back forward and lay it down on the rear seat. Next remove the rear deck. There are 2 plastic push-in clips that hold the rear deck. They located toward the front. ...

...remove back seat to get to fuel pump drivers module Grap the from of the seat on either side and pull up forcefully. The retainers will pump and you will be able to remove the seat. It is rarely the ...

...to it and I need to get into my trunk now. I have removed the seat and everything, I just can't get my trunk open from the inside. Help me? can you fold back seat and try to rich from in

...the seat covering will need to be pulled apart so that new heater can be installed. you will need to ring the fastener and carefully pull covering back, to have room to remove old one and

Question about Mercury Sable

1 Answer

...mount or if its in another location where do i find it the top bolts are basicly in the back window of the car you have to remove the back seat and the panel below the back window and there right ...

...Remove the luggage compartment scuff plate. Pull back the luggage compartment carpet. Disconnect the rear lamp assembly electrical connector. Remove the nuts. Remove the rear lamp assembly. Pull the ...

...remove the back seat to gain access to the three mounting nuts of the upper strut mount. Then you can remove the nut and bolt that pinches the the rear spindle assembly to the lower strut. separate ...

Question about Mercury Sable

1 Answer

...remove the two bolts on the very bottom retaing brackets then push the seal as hard as you can straight back to the rear and lift upward then you can take it out it will be very hard to push back I ...

Not finding what you are looking for?
2000 Mercury Sable Logo

977 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...