2006 Jeep Liberty "car clunking 40 mph" Questions

...park to drive, and it starts to rattle/vibrate at about 40 mph or higher. Ball joints are u joints seem to be fine. what else could it be? check motor mounts defective ones can cause engine to ...

...40-50 MPH and at 70 mph does the same sound. If you accelerate and back off the go again it sounds like the transmission is clunking but the transmission guy said it wasn't the transmission. HELP!!! ...

40 mph or better yet, have it diagnosed and repaired I wouldn't recommend going 70 mph ever. You lose a drive shaft, you could loose control, roll over or worse Have the driveshaft joints and the rest

...clunking noise definitely coming from the bottom of the vehicle but when i exceeded to a speed of 55mph or greater it stopped and didnt start back until 2hrs later and 30-40 mph, it doest make a ...

...car jerks when I let off the gas, it is most prominent between 40 and 60 mph. Also when accelerating(floor it) causing transmission to down shift there is a jolt and audible clunk. Check Your Motor ...

...40 mph Vehicle shakes/vibrates when driving at 40 mph Could be alignment struts or tires. If it pulls to one side and your front tires are warn on the inside more then its most likely alignment. If ...

2005 jeep liberty sometimes clunks when shifting under 40 mph Drive Line U joint

40 - 45 mph but lately won't shift unless I play with gas pedel then will down shift for no apparant reason while on road causing very high RPMs. sounds like trans has gone bad, last service of filter

clunking/knocking noise when I accelerate from a dead stop and keeps doing it until I reach 30 to 40 mph. Any idea of what it could be? LOOK FOR LOOSE DRIVE SHAFT BOLTS IF ALL LOOK GOOD YOU COULD HAVE

...40+MPH on smooth highway. Single "clunk", nothing more for 2 - 10 minutes, then recurs. Now occurs on every journey of 10+miles. Any suggestions on cause, please? check the drive line "U" ...