1995 Mercury Villager "air" Questions

overheating 95 Merv Villager. had to replace radiator, and has been overheating since. I bled the air out of cooling system, and the heater blew hot air again. overheating continued, esp at freeway ...

air blows cold in rear but warm in front vents. If it is cold in the rear, that eliminates the "freon" part of the system.  (It apparently has enough freon and the compressor is apparently ...

why getting excess air in gas tank? when opening gas cap expulsion of air realeases every time. After about ten miles the car begins to hesitate as if you were putting your foot on and off the gas. It

Front heater blows luke warm air - rear heater blows hot air and works fine. what causes this? air trapped. go here. need flush, evac/fill from shop with this equipment. go here ...

iat sensor replacement Do you mean an IAC = Idle Air Control? It is located on the Drivers Side of the Throttle Body IAT (Inlet Air Temperature) Sensor? It is part of the MAF (Mass Air Flow) Sensor on

...and the thermostat. The radiator is fine. What else could be causing the van to overheat? You have air trapped in the system. If you have cold air, warm air, cold air from your heater, then it's air ...

...at red light i cked the coolant and overflow added some and drove still doing same thing hot air when i drive but at stop cold air, i will reck coolant when car is cooler but is ther anything ...

Put new AC compressor on, ice cold air for 2 days then blowing cool to warm air. Compressor is working but air not cold. Sometimes will get a small burst of cooler air but doesn't last.  You ...

how do i tuneup what parts do I need Plugs, air filterPCV. Valve, oil oil filter and some CRC electrical cleaner spray to wash off the mass air flow sensor Sensor is delicate so spray clean and air ...

IAT SENSOR LOATION OF IAT SENSOR The IAT is part of the MAF Sensor (Mass Air Flow) which is located on the Air Intake Tube between the Air Filter and the Air Intake/Throttle Body