1990 Subaru Legacy "reading obd scanner" Questions

..."select monitor" scanner for OBD-1 cars. You also have to know which connector is the OBD-1 connector, it's among many connectors that are up under the drivers side dash . I hope this info

...scanner hock up plug.can i buy a code reader in toronto. engine was starting very well until light come on.what else can i do without takeing into have it scaned does code neen to be cleared after ...

...cause this is very hard to replace and very expensive, so get the the engine control system tested, this is what is called OBD 1 electronic engine control and requires a Subaru scanner to read

...OBD Scanner Will NOT Communicat When Pluged IN, and 'read codes' is pressed it read out must connect to VEH TO RUN THIS TEST Checked pins they are good and tested 2006 F350 Power stroke truck ...

...scanner designed for the older OBD codes. The connection port is under the dashboard near the bonnet release lever, (See photo). Turn everything off. Make sure the plug is pushed well into position. ...

eng. light is on.How do I read codes now? OBD 11 scanner reads from 1996 to later models, your car is obd 1 and needs obd 1 scanner there is other way but for that you need the automobil manual repair

...scanner. There should be two OBD ports on this vehicle, one under the steering wheel the other is located by the computer unit under the hood. Attach an OBD reader or OBD II Reader (available to be ...

...OBD but the scanner does not read anything at all. the bulb may have gone out and check the back of the obd plug to make sure no one pulled the diag wire from the plug assembly. Check for power and ...

...OBD l scanner for a 95 dodge Dakota for under a $100.00, or can I use a OBD ll scanner with an OBD l adapter and achieve the ability to read and clear codes? An OBD2 scanner can sometimes read an odd ...

...reading! Go here for a away around using obd. http://www.youtube.com/watch?v=8M5BaAa6tCM what type of scanner are you using? for a 1996 honda you need to use a obd1 scanner using anything else wont ...