1991 Honda Accord "timing belt marking 91" Questions

to the timing belt and re_check the marks for the timing belt this are on the camnshaft and cranck shaft put on the EXACT position .I think is all what you need if is not explain with more details tnk

...timing marks are still lined up. If so, you're good. If not loosen the belt again, but this time move the cam sprocket 1 tooth advance and do the same thing over again. This should be right on the ...

...timing belt. The other, shorter one drives the balance shaft and is referred to as the balancer belt or timing balancer belt. Use a piece of chalk or a marker to place an identifying arrow on the ...

...timing belt can you help me from autozone.com: 1990-95 4-Cylinder Accord and 1992-95 Prelude Disconnect the negative battery cable. Turn the engine to align the timing marks and set cylinder No. 1 to ...

timing belt. I replaced it but now it pings under a load what is wrong? Check and adjust ignition timing If it is pinging under load, your timing is not correct.  It may be that the cam timing is

belt tension, fill the reservoir and bleed the air from the system. Tighten the bolts/nuts to the following: 1984-85 Accord and Prelude pivot bolt 32 ft. lbs. (45 Nm); adjusting nut 20 ft. lbs. (27 Nm

...timing belt Here is your diagram, Please leave me a FI YA comment if I fixed ya thanks ...

...timing belt is broke, how can reemplace and Ford ranger 91 the timing belt is broke, how can reemplace and check timing Take off the alternator belt, tensor, fan and cap of timing belt, review the ...

...timing belt cover. There is a notch in the pulley to mark TDC (Top Dead Center) Align the notch with the 0 mark on the plastic cover to set your base timing. Ground the proper circuit on the ALDL ...

timing belt, did you make sure to find top dead center on cylinder 1 ? Just lining up the timing marks may not have worked if this is indeed what you did.If you had the crankshaft rotated 180 degrees,