...pulley.support motor and remove motor mount bracket. take off upper and lower timing belt covers.take off timing belt and other belt using the tensioners.take off and replace water pump CHECK ALL ...
...Remove water pump pulley. Disconnect coolant inlet and by-pass hoses from inlet pipe. (2) Remove coolant inlet pipe and "O" ring from rear of water pump. Remove oil dipstick tube and plug hole in oil ...
...next to it, then remove the 4 bolts in the pulley Make sure you support the engine with a floor jack, use the jack to raise the engine a few inches on the that end helps getting the pulley bolts
...PULLEY. REMOVE THE RIGHT SIDE IGNITION COIL.REMOVE THE WATER INLET HOUSING AND THERMOSTAT.REMOVE THE MOUNTING BOLTS AND STUDS. LIFT OUT THE WATER PUMP BY CAREFULLY PRYING BETWEEN THE PUMP AND THE ...
...shaft and cam shaft be moved with the timing belt removed. You no not need to remove the water pump. You need to remove the water pump pulley only (not the water pump). I trust this helps. Regards ...
How do I replace a water pump pulley on my 91 cadillac fleetwood remove 4 10 mil bolts.
...remove crankshaft pulley,. if u change water pump i suggest u change timing belt too while your there . . the hardest thing is to deal with the timing you have to line it up perfect so it can start ...
...remove the water pump. If the belt was just placed back on the pulley without setting the timing marks, then the engine is out of time. There were two engine types that your Mazda could have been ...
...Remove the water pump pulley. Matchmark the crank angle sensor to the upper front cover and the remove it. Carefully position it out of the way. Position a floor jack under the engine and raise it ...
3,428 questions posted
Usually answered in minutes!
2,998 Questions
1,631 Questions
1,636 Questions
1,570 Questions
1,470 Questions
