...half inch breaker bar trying to get it offf) next use puller to take off crankshaft pulley.support motor and remove motor mount bracket. take off upper and lower timing belt covers.take off timing ...
...inch lbs. (10 Nm) Radiator hoses and tighten the clamps Lower splash shield Negative battery cable Fill the cooling system. Start the vehicle and bring the engine to operating temperature. Check for ...
...half inch drive breaker bar, see the square hole in the top? Put the breaker bar in there and torque it up, tighten the bolt. The other is the alternator and the other is the AC compressor, Of course ...
...is for the end of a half inch drive socket, a breaker bar will do it. loosen the bolt and torque it over with the breaker bar, the belt will come off, and tighten it up the same way. Hope this
...inch lbs. (13 Nm). Install the front rocker arm cover. Install the thermostat housing. Connect the upper radiator hose to the thermostat housing. Fasten the coolant inlet pipe to thermostat housing. ...
...inch lbs and most people don't have a wrench for that. Best rule is to use a nut driver (like a screwdriver with a socket end) to avoid over tightening and, don't tighten so much that you can see the ...
inch drive adjustable torque wrench (recommended) Impact screwdriver with Phillips head bit Hammer Bungee cord C-clamp Brake clean spray Shop rag(s) How to Replace Front Rotors on a Mazda6 Step 1 Park
...half-inch drive torque wrench and spindle socket.18Replace the brakes in the same manner you extracted them. You may need to push the caliper piston in a bit with a C-clamp to get it over the rotor. ...
...inch. If successful, you can feel the thread break loose. If not, keep trying (th alternative is taking to an auto shop and paying $100s in labour). Make sure the socket is snug, tension the ratchet ...
3,428 questions posted
Usually answered in minutes!
2,998 Questions
1,631 Questions
1,636 Questions
1,570 Questions
1,470 Questions