Filler hose D Wiring harness from clip EClean area and unscrew fuel tank sender/pump cap or equivalent. Remove tank sender/pump and seal. Remove pump from sender/pump assembly.INSTALLATION Inspect the
Question about Ford Cars & Trucks
...installing the reservoir, the filler neck must be lubricated using a water-based lubricant. Remove the bolt and the windshield washer reservoir filler neck. Remove the RH fender splash shield. For ...
...filler neck and remove from shroud retaining loops. Remove the four (4) viscous fan/drive assembly nuts from the water pump pulley and remove fan/drive assy. Remove the four (4) fan shroud to core ...
Filler Neck Protector Bolt (3 Req'd) 12 9B240 Fuel Filler Neck Protector 13 9N127 Fuel Tank Support Strap Hinge 14 ? Fuel Tank Filler Pipe Bolt (2 Req'd) 15 9030 Fuel Tank Filler Cap 16 9080 Fuel Tank
...neck in place. The design of the steel-core factory gasket is such that it may be reusable, if not bent or otherwise damaged. Note that most replacement transaxle oil filters come with a new gasket. ...
...on the firewall, the vacuum supply hoses to the vacuum source and the heater core tubes. 9 Refill the cooling system with fresh coolant--half water and half antifreeze--at the radiator filler
...filler neck and the vent tube hose. Remove the gauge hose which is attached to the frame. While supporting the tank securely, remove the support straps. Lower the tank until the gauge wiring can be ...
...filler neck on 2000 Crown Vic I need to install new filler neck.The only problem with it is the little spring loaded tab was damaged when someone tried to steal gas so they say I have to replace the ...
...filler neck as possible. Use a siphon to remove the remainder of the fuel in the tank by connecting the siphon to the fuel pump outlet fitting. CAUTION Never drain or store fuel in an open container ...
161 questions posted
Usually answered in minutes!
299 Questions
116 Questions
117 Questions
74 Questions