2000 Lexus RX 300 "change gear shift sensor" Questions

...change also gear all of a sudden is not going into the 4th gear Knock sensor controls ignition timing. It should have no control on transmission shifting. Did you disconnect/remove anything else to ...

...gear operates properly also when you first crank it when motor is cold it will sometime go into overdrive 75% of the ti,e then it just stops. other than overdrive transmission seems fine shifting. ...

...gear clutch and it might not be a transmission problem. All top secret. never call a dealer if you just want answers. Take to a trans repair shop and have it service. They will drop the pan to change ...

...gear but as soon as i change to park or anyother gear.wont work. Please help I changed speed sensor Safety neutral switch Shift solenide The problem is a gear internal failure the gear who drive the ...

problems. These components connect the gear shift lever to the transmission. Inspect and replace any damaged parts. Remember that diagnosing transmission issues usually requires professional expertise

...gear and does not change. When coming to a stop it does not downshift but seems to stay in a higher gear. Also, the check engine light is on. run the fault codes to find the problem sensor could be ...

...cleared codes shifted once and would not shift again states gear 2 incorrect ratio gear 1 incorrect ratio Check the input shaft and output shaft speed sensors on the transmission. One is likely

...change the hydraulic pressure sensor. I even put the old one back in and still couldn't get third gear. You can only diagnose problems like yours with a pro grade scan tool computer as opposed to a ...

...gear. Had the Tranny fluid checked, it's fine. Help. Your going to have to get your car scaned for codes. Auto Zone can scan it for you for free and tell your what you'll need to fix it. It sound's ...

...change to 3rd gear, now it displays code P1714 but I already changed the shift solenoids. Any one knows what the problem can be? it could be a vacuum line from tranny to motor might need put back on ...