1997 Mercury Villager "fuel port check pressure" Questions

...port on the fuel rail now tighten gas cap re-connect the fuel relay and turn the ignition switch on and verify the pressure it should be 37-43 psi.If not within these specs then replace the fuel ...

...and plug it with a golf tee. Start the van and watch for fuel to come out of the vacuum port on the regulator. If it does, replace the regulator. If not, please get back to me for additional

port on the fuel rail. It should be a small, circular port with threads on the inside. Attach the fuel pressure gauge to the test port. The gauge will have a hose with a fitting on the end that screws

...fuel rail test port. Connect the 0-414 kPa (0-60 psi) fuel pressure gauge (from gauge set 5069) to test port pressure fitting on fuel rail (Fig. 7). The DRB III Scan Tool along with the PEP module, ...

...fuel pressure relief port act like it is starving for fuel when you are diving so i want to check fuel pump pressure before i buy one I don't think those motors have a test port.  You'll ...

...port, you have to tee off the fuel line somewhere convenient (like right after the fuel filter) and hook your gauge up there. Hook the gauge up, make sure of no leaking, turn key to on, and read the ...

...port located on the fuel rail where you would conect the pressure tester. The test port is usually located on the drivers side of the engine near the rear section coming up from the firewall. Unscrew ...

...port located on the fuel rail where you would conect the pressure tester. The test port is usually located on the drivers side of the engine near the rear section coming up from the firewall. Unscrew ...

...port, fuel filter and inspect the whole fuel line for kinks & crimps. If that doesn't work disconnect the fuel filter then use high pressure air to blow from the pressure regulator to the removed ...

...fuel pressure test port on the top of the engine in the pipe that delivers fuel to the injectors. You will need to buy the special gauge that hooks to this test port. The test port looks like a large ...