2002 Honda Civic "change dash" Questions

...are dim If you look at the dash it seems the parts of the driver dash is dim as compared to other parts of the dash bad bulb somewhere Remove your cluster and change the bulb at the back very

...change the dash controls to see what is happening. If the actuator tries to move the air door in question, then the door is stuck. If you don't hear or see anything happening with the air door, the ...

...dash or guage. I have seen other fuses blown that affect other circuits so check all fuses. Hi from Spain , check too if your positive and negative cables from battery has Green rust ... If its your ...

...change new thermostat new coolant made a little mess filling reservoir checked fan fuse and condenser fan fuse temp guage is slightly lower on gauge disconnected quit a bit to get to thermostat no ...

...pump went bad, I changed that also changed the fuel filter, air filter, the oil, and the coolent. But I'm still having problems when it doesn't start 12vot relay under dash behind change left hand ...

...dash come on, but no sound what so ever.... I took off the starter and had it tested, they say it works fine... but could not ck the cylinoid on the stater. I am lost for what to do... dont know were ...

...dash is a change, etc. fold out compartment. I have found it is easier to reach the relay if that is removed (couple of small screws, bolts). The relay is basically tucked up under the left side of ...

...change.been sitting for 6 years.. try changing the main relay under the dash Check your air flow to the throttle and the hose's sometimes the heat of the motor melts it a little and airflow gets ...

...dash will start to flash, release the button and press it down again and keep holding it until the display stops blinking. All done. Hi, honda's come with a light system to tell the driver when basic ...

...GOIN IN, I ALREADY CHANGE THE CONTROLS IN DASH BOARD, I ALSO CHANGE THE RELAYS. low pressure switch may work off a ground you need to check if you have 12 volts and a ground at compressor clutch ...