...pilot. To make sure that the yoke seats squarely on the flange, tighten the bolts evenly in a cross pattern as shown. Connect the driveshaft. . Install the rear brake calipers. Install the rear wheel ...
...rear disc brakes.Brake DrumsRemoval & InstallationRemove the access hole plug, then back off the adjusting screw Exploded view of the drum brake system Raise and safely support the vehicle with ...
...pilot hole. Carefully remove the brake drum from the vehicle. After removing the brake drum, it should be checked for the following: Inspect for cracks and deep grooves. Inspect for out of round and ...
...pilot is not binding in the engine crankshaft. Install and tighten the converter housing-to-engine attaching bolts to 40?50 ft. lbs. (55?68 Nm), making sure that the vacuum tube retaining clips are ...
...pilot diameter, tap the center of the brake drum between the wheel studs.(I use pen.lub spray) Loosen the brake shoe adjusting screw nut (2K389). (rear of backplate star adjusters.(takes skills , all ...
Question about Honda Civic
...pilot is not binding in the engine crankshaft. Install and tighten the converter housing?to?engine attaching bolts to 40?50 ft. lbs. (54?67 Nm). Make sure that the vacuum tube retaining clips are ...
pilot is not binding in the engine crankshaft. Install the converter housing-to-engine attaching bolts and tighten them to 65 ft. lbs. (88 Nm) for the diesel; 50 ft. lbs. (68 Nm) for gasoline engines.
906 questions posted
Usually answered in minutes!
1,130 Questions
1,041 Questions
758 Questions
811 Questions
722 Questions