1993 Honda Prelude "connecting rod nuts" Questions

Ad

...connecting rods have been removed as well as the balancer shafts I just need to get the bridge assembly of to properly clean the block and have it honed are there any tips as to how to get it off ...

Ad

Question about Honda Prelude

2 Answers

...connecting rod corolla 89 55-60 foot pounds PISTON & ROD ASSEMBLY & ROD BOLT REUSE Piston & Rod Assembly & Rod Bolt Reuse for 1989-99 Toyota 1.6 & 1.8L 4A-FE & 7A-FE Engines ...

Ad

Question about Honda Prelude

1 Answer

...connecting rod nuts for these engines use a combination torque, then turn method to achieve the proper clamping load. First the nut is torqued to 18 lbs.ft., then turned an additional 90°. It is ...

Question about Honda Prelude

1 Answer

connecting rod and Pitman arm. Disconnect the drag link using a tie rod end remover. Loosen the bolts on the adjuster clamp. Count the number of turns it take to remove the drag link from the adjuster

Question about Honda Prelude

1 Answer

mazda protege i need to take off an outer tie rod end on the drivers side. is the first nut backwards threaded? hello dusto, no it should not be. the nut on the tie rod end which connects it to the ...

...connecting rod. INSTALLATION: 7. Install the tie-rod end into the adjusting sleeve or connecting rod. Thread the tie-rob end in until the marks made on step 6 align. 8. Install the tie-rod end to the ...

repair inner tie rod end of 1997 dodge avenger #3 is the inner tie rod and it is simply screwed into each end of the steering rack. Raise and support the car remove the wheel and you should see where ...

Question about Honda Prelude

1 Answer

...connecting rod caps? According to Torkspec.com, for GM 4.3l 262 ci V6 the specs are as follows; Type: Dim: Length: Head: Nut Grade: 20 Ft-Lbs 240 In-Lbs 27.12 N-m Connects: Connecting Rod To Engine ...

...nuts; Torque to: 46 ft. lbs. (62 Nm) Tie rod ends Steering dampener to the relay rod, if equipped Engine protection shield, if equipped Lower the vehicle Check the wheel alignment Test drive the ...

2001 Dodge Caravan outer tie rod how to install it macking noice and shold i change stiblizar too loosen nut on tie rod..22mm wrench,remove nut from tie rod end..18mm socket,hit side of knuckle with ...

Not finding what you are looking for?
1993 Honda Prelude Logo

228 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...