1993 Honda Prelude "12 volts coil spark plugs" Questions

...12 volt if the battery is charged. If the voltage is less get the battery charged at local auto repair shop. If the battery is internally drained and not getting charged then its time to replace the ...

...12 volts) to high voltage (about 50,000 volts) to fire the spark plugs and ignite the fuel in the engine cylinders and drive the piston down IGNITION COIL FIRES SPARK PLUG MAKES THE SPARK.WELL I CALL ...

...12 volts to the coil when you turn ignition switch on if not you will never have spark from the coil going to the plugs. If you do have 12 volts to the coil and still no spark you have a bad coil. To ...

12 volts on both wires why is this should I have 12 volts on wires going to pickup in the distributor if so which wires should be hot??? 12 volts at the low tension wire , hundreds at HT (high tension

...12 volts directly to distributor to se if I could get a spark and nothing. run the fault codes first as there are a number of reasons for no spark --the last being the coil. There is an ignition ...

...12 volts to the positive side. Voltage should be applied very quickly, and and disconnect right away, do not leave the battery connected for longer than a fraction of a second or you will burn up the ...

12 volts at ignition coil, 12 volts out to distributor, no spark at coil to distributor (center wire), all fuses look good, new ignition coil (no change), battery good, change out your distributor cap

...sensor, only getting 1.45 volts from ecm, 12 volts coming into the pick up ignition box, but no spark from coil to spark plug. Do you have a spare coil to test? Coils can be a failure point as

...12 volts let start with fuses in the engine juction box (there not mark to what it belongs to) make sure none are open. especially fuse 19 and 24 , next go to the crank sensor make sure the tabs are ...

...12 it will not start an run it 318 A standard ignition coil normally generate about 15,000 - 25,000 volt depending the requirement to spark the spark plugs. The input volt should be 12 volt but the ...