1 small up and the other cam small half moon down . 7 - slightly turn the cams left or right to be able to fit tool in slots . 8 - With tool in place re-install cam-drive belt w/# 1 piston at TDC . 9
...up the cylinder to be able to set up the cams for the belt this is a double overhead cam Move the cams to a dfferent location, set your #1 to TDC, then rotate the cams where the marks need to
Question about Acura RSX
Where is bank 1 cam shaft position sensor location on my 2004 Saturn vue 2.2 L Location bank 1 cam shaft position sensor ? you have one bank .This vehicle does not have a cam sensor . The ICM provides
cam position sensor bank 1 does anyone know where the cam position sensor bank 1 is located on a trailblazer I6? cam sensor is in the cylinder head next to number 1 cylinder.
Question about Cars & Trucks
Hi trying to set the timing on my j1 elantra its a 16 valve and each cam has two marks on it.so my question is what positions should the cam lobes be at when timing is supposed to be correct.thanks no
...cams), Then align the Intake Cam to mark on #1 Cam Cap, "Now" loosen the 17mm bolt to tighten timing chain, rotate engine using rachet two times, reset TDC at the crank, and look at "Cam Timing Marks ...
1998 toyota 2.2l, camshaft timing marks first off its a timing belt second there is a yellow factory mark on only 1 cam and thats cause only 1 cam is driven by the belt the exhaust cam is gear driven ...
2003 nissan altima how many cam postion senors does it have If you have a 4 cylinder you have 1 cam sensor and 1 crank sensor. Both parts are the same. If you have a 6 cylinder, then you have 2 cam ...
...sensor A so by banks I take it that it is the LH cam (from front of engine) bank 1 and RH cam is bank 2 correlation means that both cams have to read at the same time to indicate a cam has not ...
76 questions posted
Usually answered in minutes!
136 Questions
104 Questions
30 Questions
28 Questions
2 Questions