i have a 95 jeep with no fire to coil changed coil and pickup module still no fire to coil Have you checked the crank sensor?
...pickup coil which is located close to the distributer change the computer .... PCM get a used one it fixed mine had same problem for testing, there are some u-tube videos that show each circuit being ...
...position sensor located between flywheel and trans is where the power source for the coil comes from. I suggest you need change that Check the distributor ignition pickup coil in the
1996 Jeepgrandcherokeelimited 5.2 engineIm not getting power to ignitioncoil changed crank sensor still nothingAlso checked relays all good. replace ignition coil check your pickup in the distributer
otherwise, you will get bad info...obviously whichever part is doing this works fine cold. ones that react most to heat are crank pickup, ignition coil and the fuel pump.(bad ones get hot and bind up
...coil IAT sensor. amd still stalling ????? I need help you need to check the fuel pressure,and did you mean you replaced the distributor or just the rotor because inside the distributor is a pickup ...
...pickup or crankshaft position sensor. No spark would point to a bad module or coil. Measuring ignition coil primary and secondary resistance can rule out that component as the culprit. Tell us
My jeep cranks over but will not start hello, check your pickup coil in distributor, if no fire, if its firing, may need fuel pump, these were bad about fuel pump going out on them.,.
...fuel pump , replaced crankshaft sensor , and pickup coil (camshaft sensor) cleaned engine ground and body ground still runs for a while and will stall did you check the fuel filter or the
3,837 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,521 Questions
2,639 Questions