...blend door actuator by removing the glove box. The actuator will be in the left corner of the glove box opening. If you remove the actuator you will be able to turn the pin. If you can turn it 360 ...
...blend door linkage reachable from under the pass. side dash? with out takeing out the whole dash? no u must remove the dash. This actuator is located on the front of the HVAC housing to the right of ...
...Blend-Door-Heater-Repair_W0QQcmdZViewItemQQhashZitem3eef1e1cd6QQitemZ270299700438QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories I used something similar to this and now have heat that is controlled ...
...blend door actuator. It separates the driver and passenger side from getting air on the AZC system. Here are some instructions on replacing it: The passenger side blend door actuator is used on all ...
...cherokee and bought the heater treater blend door repair kit. it really does work and you can fit it yourself in around half an hour. kit comes with all you need and full instructions.. hope this ...
...blend door motro may be bad, this motor is screwed to heater box, there are a few of these motors one for pass/side for hot/cold air then one to control position of air like defrost or vent or floor, ...
...problem is a blend door not moving properly. Unfortunately, most controls on your heater box are inaccessible and the entire box needs to be removed (big job, get a manual or have a shop do the
...not cheap. Sounds like the tipical problem with heaters. there is 3 blend door motor in the heater box in the dash,and one of them is bad. send a clip on a heater core replacement to give you an ...
...driver and passenger temp control, one side will blow cold the other hot, and it is intermittant this model has a couple of possibilities, updated heater control panel which is quite an expensive ...
3,837 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,521 Questions
2,639 Questions