Question about Jeep Grand Cherokee
...cable from the battery. (2) Drain the cooling system (refer to Group 7, Cooling System for the proper procedures). (3) Remove the generator (refer to Group 8B Battery/ Starting/Charging Systems). (4) ...
...set of high-quality wires is worth the cost. They may be permanently attached to the distributor cap, so it will have to be changed as well. Step 3 Replace the distributor cap and rotor if your car ...
...wire that gets dirt on it and sends an incorrect signal to the engine computer (PCM) on how much air is entering the engine, this will cause a hesitation and other problems, this will not set a ...
Question about Jeep Grand Cherokee
...making sure all high tension wires are firmly secured in cap towers. Connect pick-up leads and negative battery cable lead. Set ignition timing, refer to ADJUSTMENT PROCEDURES for timing ...
Question about Dodge Cars & Trucks
cable to the distributor and unhook the air cleaner tube. Unscrew or unhook the clamps holding the distributor cap in place, and unscrew the Camshaft Position (CMP) sensor connector with a screwdriver
...set gap to spec from tune up booklet. Hi Reggie, Remove the distributor cap, the rotor arm and the plastic cover from inside (if its still there). Loosen the lock nut and the securing nut from ...
set timing at 10 degrees btc. 1954 100 stepside 292cid.v-8engine from 1957-1964 do I need a new distributor? hi no not really a new distributor, have you tried adjusting the idle screw on the carb? or
...set when the EST bypass connector is disconnected. Aim the timing light at the timing mark. The line on the balancer or pulley will line up with the timing mark. If a change in timing is necessary, ...
set Park Brake 2 Ensure all accessories are off AC ,Heater, Radio, ETC... 3Connect an inductive timming light and Tach to the Engine according to manufactures instructions 4 disconnect the single wire
...set timing on 84 ford e350 ,351winsor at 10degrees btdc is this right? yes 10 deg is correct hope this helps FixYa leave feedback Clean the timing tab, located just above the harmonic balancer on the ...
2,181 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions