1993 Jeep Grand Cherokee "coil" Questions

Ad

Question about Jeep Grand Cherokee

3 Answers

po351 jeep p0351 is ignition coil primary circuit this USUALLY means a bad ignition coil use only a name brand coil ,but it could be a bad computer but not very common check wiring to ignition coil A ...

Ad

Question about Jeep Grand Cherokee

1 Answer

...this code. If it is B1391 that would be the only code with 1391 for your vehicle. P0351 - Ignition Coil A Primary / Secondary Circuit Malfunction. The ignition signal from the Powertrain Control ...

Ad

Question about Jeep Grand Cherokee

1 Answer

no spark when cranking over check coil wire corrosion at coil terminal. if ok, check for power to coil with key in run position. if coil wire removed from coil, and engine is cranked, does it arch to ...

Question about Jeep Grand Cherokee

1 Answer

95 grand cherokee straigt 6 cyl replaced coil 3 times in 2weeks. now i have no spark out of coil ut have 12 vots to coil what makes coil burn out? or some other problem? How does it run when you put ...

Question about Jeep Grand Cherokee

1 Answer

...is turning over but jeep wont start. Please check if there is spark at the output of the ignition coil, situated on the left side (passenger side) of the engine. 1. Get a paper clip. 2. Remove coil ...

Question about Jeep Grand Cherokee

2 Answers

no spart from coil If the coil has no spark, the coil pack is most likely bad. In order for you plugs to fire off, it has to receive spark from some type of coil. i have no spark to the plugs and ...

Question about Jeep Grand Cherokee

1 Answer

1997 jeep grand cheerkee tunes over but won,t start no fire from coil to distributor So you have B+ to coil but no B+ from coil to distributor. Sounds like the ignition module. Its not triggering coil

Question about Jeep Grand Cherokee

2 Answers

...of spark plugs . I believe that year had distributorless ignition, instead it uses a form of coil on plug ignition system. If you open the hood, stand at the front of the vehicle. Look to the ...

Question about Jeep Grand Cherokee

1 Answer

how do I fix Diagnostic code 351 1. Check for power to the ignition coil when cranking. 2. Check continuity between the Powertrain Control Module (PCM) and the coil on the coil ground circuit wire. 3.

1999 jeep cherokee does not start, tried cp sensor still no spark , batt. voltage at coil on one pin during cranking, coil checks ok with ohm meter.pulled up fault codes and there were none. should ...

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

2,181 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...