...front tire. Tires, brakes, rotors all less than a year old, could it be a hub/bearing assembly or something different? Thanks in advance. Hi and welcome to FixYa! Looks like a wheel bearing issue. If ...
...front brakes make sure it hasn't been damages and laying against the rotor. If you don't see anything, then try turning the rotor by hand and see if you hear the sound. If you hear the grinding noise ...
...front end grinding and rumbling ?? rotor was checked out and was ok, almost sounded like 4 wheel drive was trying to engage in 2wd causing grinding and rumbling, I put it into 4 high and it went away ...
...front wheel bearings on the Escape are simple cartridge bearings, or Gen1 bearings, that are pressed onto the hub and knuckle. They are not so simple to replace. Unless you have the experience and ...
Question about Mercury Mountaineer
rotor and caliper on rear right. Has vibration and howl at low speeds and worse at deceleration from high speeds. All seems tight and secure in front end. Front wheels seem tighter than back, no play.
...front wheel bearings on the Escape are simple cartridge bearings, or Gen1 bearings, that are pressed onto the hub and knuckle. They are not so simple to replace. Unless you have the experience and ...
...front tires off. If this metal tab is even lightly contacting the rotor, it will cause an intermittent squeal. You can tell if it is touching the rotor because there will be a smooth wear pattern on ...
...front drive line balanced with new u-joints installed. I'm at a loss. check wheel bearing if they are bad some have to be replaced as a hub assembly. I had the same issue on my 05 2500HD. The wheel ...
...front rotor 2001 jeep grand cherokee Normally, to remove a front rotor you remove tire, then must remove the caliper. To remove caliper, there are two screws that the caliper is secured with that are ...
...rotor. I have pounded out the broken studs. I have pounded loose the remaining studs but are unable to remove them due to clearance issues. I have removed the hub assembly bolts that hold the stems. ...
866 questions posted
Usually answered in minutes!
658 Questions
555 Questions
377 Questions
323 Questions
250 Questions