2001 Chrysler PT Cruiser "01 crank sensor" Questions

crank sensor IS what fires the coil packmixing the two years sounds like the problemcheck wire harnes see if the 01 powers the 05 the same termail01 senor and pack may have to go back   

...sencor on a 01 pt cruzer the crank sensor is located in the transmission bell housing where the trans bolts to the engine block.its held in by one bolt and is a 2 wire round plug connector i

01 pt cruiser it has rough idle and when you start down the road it will be fine one min and the next it jerks and you can press on the gas and its like there is no power and it gets worst if you turn

Replaced timing belt on 01 pt cruise, timing marks are dead on but will not start, smell gas Did you hook back up crank sensor?

...crank sensor on 2005 PT Cruiser? It absolutely is not above the oil filter as on 01-03 PT's. REMOVAL - 2.0, 2.4, 2.4L TURBO The Crankshaft Position Sensor is in the front of the engine block just ...

...01 PT Cruiser. As I was driving home from work today my car died. I pulled over and tried to restart my car, and it cranked but wouldn't start. I asked someone for a jump and the same thing happened, ...

...01 PT Cruiser with 115,000 + miles. The car runs fine for about 15 miles then stalls. Car will not start for about 10-15 minutes. When car starts, it runs perfectly for another 10-15 miles. I thought ...

01 PT would not start(EGR Valve)at 75,000 & 140,000 crank position sensor.First time ran bad second time just died and wouldn't restart.Well hope the key thing still works and good luck.If you can

...crank is also different. It can not read correctly to time the engine. You cant swap the computers to make this work either, and also the o3 does not have an egr valve and the 01 does. It all comes ...

crank it up and it would turn over but wouldn't fire. I should also say that it would occasionally run next hot and lose water and the heater smelled like antifreeze when it was on. I called around to