Question about Chrysler Town & Country
can I put a 2003 town & country transmission into a 2002 town & country I am looking to replace the transmission in my 2002 Chrysler Town & Country. Can I put a transmission from a 2003 ...
Question about Chrysler Town & Country
2002 chrysler town & country running rough after tune up replaced hoses for EVAP system, plugs, plug wires Check the evap hoses are seated correctly,also check for any small vacuum hoses that may ...
My 2002 Chrysler Town & Country wont start It will start after I put the gas pedal to the floor a few times, but if it sits overnight it takes a while to get it started, but once running for awhile it
Question about Chrysler Town & Country
2002 Chrysler Town and Country Rear Heat/Air only on High 2002 Chrysler Town and Country Rear Heat/Air only works on high. THink it is blower resistor, but don't know the location of it to replace it.
I have a 2002 dodge caravan and it suddenly shuts off. my mechanic cant find the problem. what could it be? It sounds like the fuel filter may need replaced. If that doesn't take care of it you need ...
p1684 codes p1281 Had a mechanic replace the thermostat and gasket in our chrysler town and country 2002, after these two error codes came up(p1684, p1281). The temperature gauge seems to be rising ...
Question about Chrysler Town & Country
2002 chrysler town and country wont leave limp mode I have a 2002 town and country that one day decided to go into limp mode. Codes both 0700 and 1684 were showing up. I changed both the input and ...
Question about Chrysler Town & Country
2002 town and country shuts off immediately after being started replaced starter. Starts but does not stay on Start at the ignition switch for losing power in run position. then look at run relay. ...
Question about Chrysler Town & Country
2002 T&C Limited (every 40K). If the clunk you are hearing is from a one wheel bump or a sharp turn (left or right, does not matter) it may be the swaybar bushings. If you hear it when you go over a 2
...problems. 1. Cooling Fan Relay needs to be replaced. 2. Fans need to be replaced (due to burned out Fan Motor) 3. Broken Wiring between the Fan(s) and Relay If you would like information on testing ...
788 questions posted
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,079 Questions
746 Questions
666 Questions