1999 Jeep Cherokee "remove door panel tailgate" Questions

remove the interior panel by steadily pulling away the panel. You will hear the panel clips popping as you pull away the panel. Some of the clips will break...but not to worry...50 cents a clip at the

...door wagon Look for fuse panel left side under dash board, the same fuse that controls dash, is on the center, if fuses are ok go to tailgate remove panel and look for a green wire on plate light has ...

...door. Remove the screws securing the latch. Working through the large access hole, position the latch as necessary to disconnect the electrical connector and disengage the outside door handle and ...

remove the shocks and panel to get to the locks and linkage. Any help would be greatly appreciated. I had the same problem. I was able to get the back window open. I took the the 4 screws off that are

...remove the plastic panels on the inside of the door and oil it with penetrating oil.  To get it to open, take off the license plate cover carefully starting at the bottom (6 plastic tabs hold it ...

...remove 2004 toyota sequoia tailgate door panel to get access the rear tail light to install a backup camera. I don't see any obvious removal points. Slide the plastic cover off the tailgate ******** ...

...door wants to open but cannot until the tailgate window is open first. I live in snow country. Could it have froze or rusted? The snow is now all melted. And I have had no problems in the past with ...

...Remove relay RM24, that controls locking right rear door. Try activating door locks and see if fuse blows. Next try removing RM20, that controls rear hatch door locking. By the way, the numbering of ...

...door Remove the 2 bolts from handle, #2 from picture. Remove 2 screws from either side of door pane(#4) now just the clips hold it on, pull panel off at one corner and work your way around until its ...

...remove tailgate door panel on a 2006 ford freestar to fix the loose panel that holds the licence plate. how do I remove it without breaking anything? Unscrew the two screws holding the handle on the ...