1998 Plymouth Breeze "fuse starter" Questions

starter fuse when starting When this fuse blows on a consistent basis, the large majority of the time it is caused by an internal short in the starter motor solenoid. The fix is to replace the starter

...fuse keeps blowing every time i start the car Check the power wiring running to the starter for exposed wire or loose insulation. I've run into the same thing on a few Chrysler vehicles where the ...

...start If it is blowing the starter fuse you probably have a bad starter with a high draw.You might want to take the car to a repair shop and have the starter circuit tested.....I hope this helps

...fuse box.iIt may be in the front of the engine,the positive cable that does'nt go to the starter should tell you the differance.Follow the cable from the positive post that does'nt go to the engine ...

...breeze I can't tell which relay is the starter relay switch, It should be in the power distribution center, under the hood, hopefully, the fuse box cover will show you which fuse and relay is

...starter, then a fuse is most likely not the cause of your problem. If this is the case, you may be looking at a starter replacement or perhaps a starter rebuild at your local auto electric shop. ...

...starter fuse keeps blowing and it won't start I'm a ase certified tech for starters and i have a problem with a 98 breeze.It won't start and the ignition fuel starter fuse keeps blowing.I have no ...

...that power is getting to the starter with a volt meter if it is then i'd say replace the starter , if not then the relay would be my next choice , fuse box underhood next to battery .list on the ...

...starter Fuse Put new starter on and still blows starter fuse. Check your ground wires, make sure they got good connection, also make sure the exhaust is not melting the power cable to the starter, ...

...starter fuse. If you reset the computer it will run for a while till it blow s the fuse again. Bad computer? Your not resetting anything Your clearing all data-never do that Get yourself a wiring ...