12 volt test light between your + battery terminal, and your + battery clamp. Just remove positive clamp, have one end of test light hooked to clamp, and the other attached to post of battery. As long
...12 volt test lamp between the cable and the battery post, If it lights up you have a short. and you'll need to start pulling fuses one at a time until the test lamp goes out. at that point you will ...
...12 volt test light and remove positive battery lead. then hook up the test light in series ( the wire end with clip hook to cable that's off . and the pointed end for checking curcuits. goes to ...
12 volt test light from cable end to battery post ? If the light is on bright, you have a good draw. Now start removing fuses you suspect may be causing the draw, and when light goes real dim, or out,
12 volt and then turn the igntion of and recive a reading of 0 volts this would be an on off wire note: check the auxsilary postion of the turn key igntion also if there is no power to the wire in the
...12 months ago and they told dealer to fit a new battery - had four in all. what a let down this hyundai is I am exassperated as I have had three new Hyundai Accents and been so happy but cannot get ...
...12-volt test light, hook one end to the negative battery post the other end to the negative battery cable you just disconnected. The test light will glow or "light" if there is a drain. If the "light ...
...memory (KAM). If the battery positive voltage circuit loses power, all auxiliary HVAC DTCs and settings will be erased from KAM. The auxiliary HVAC control module will perform a recalibration of the ...
...memory features is usualy yellow. Black or green can be ground but use caution as these could also be speaker wire colors. If you cant find the fuse location from the original radio you can use a ...
4,552 questions posted
Usually answered in minutes!
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions
2,639 Questions