1995 Jeep Wrangler "obd2 scanner reads link" Questions

Scanner to find the problem. usually, an "AIR" code would come up in this situation; which means "Air Injection Reaction", and would point to a system fault. From there, you can inspect a multitude of

...obd2 scanner on a 2003 GMC envoy. I think I read that it was somewhere under the dashboard. buying an OBD2 scanner because "Service engine soon" light is on and the car is running a little "rough". I ...

...OBD2 scanner I got a "Link Error". So I tried to get the scanner to read the codes again only to get the same thing. Does any one know what causes a Link Error and how do I fix it. I know my Montana ...

scanner on my 96 jetta trek it wont read it any solutions Check pin number 16 of the OBD2 data link connector under the dash, it should have 12 volts at all times. See diagram below, your connector is

...obd2 certified car ? Because it is likely not up to date on CAN BUS technology, an uprade is suggested. on all scanners it says not to start the engine but a few posts for various vehicles have said ...

...have a obd2 it has 16 data link connector you have to use scanner to get codes.now the obd1 system have 12 data link connectors..the top two at far right is where you put jumper wire to retrieve

a 2006 nothing wrong other wise all fuse look to be intact THE MAIN POWER FOR OBD2 COME FROM CIG LIGHTER FUSE. IF FUSE IS OK SCAN WITH DIFFERENT SCANNER.SOME TIMES CHRYSLER DON'T LIKE GENERIC SCANNERS

scanner and the expertise to use it. Appropriate as early obd diagnostics needed type-specific software while later obd2 systems could be read by generic software, though model specific software still

...obd2 sort that can be obtained free. Your scanner is just about the cheapest available and it is extremely unlikely to be capable of reading any more than the minimum required under the law - that is ...

OBD2 Link Error comes on when scanner reads. I have a 96 S-10 that will not link to scanner. Scanner work on other GM's and all othe cars/truck i have tried it on. Dont know whats wrong. THERE IS NO ...