1989 Jeep Wrangler "hard clutch pedal" Questions

...how a clutch works: http://auto.howstuffworks.com/clutch.htm Reattaching the shafts with new cotter pins isn't hard. But if one is broken, you have to get a replacement. Try a junk yard, it's

...hard" clutch is also a common problem. All clutches require some amount of force to depress fully. If you have to press hard on the pedal, there may be something wrong. Sticking or binding in the ...

...5 gears but was hard but when i push down on the clutch pedal the first 2in of the pedal is loose then it has pressure could this be the clutch master cyl. yes it could be also check the fluid

...hard to get to second, third and so on. The clutch pedal has barely any resistance. Do I need a new clutch? Or is it just hydraulic fluid that has leaked out?? If you have a hydraulic clutch, it is ...

clutch - I was losing pedal yesterday and this morning hardly no pedal while not being able to shift into gears at all. No noise nor leaks from anywhere. Do I have a hydraulic clutch or conventional ?

...hard to engage ...clutch fluid escaping we got a 98 jeep wrangler 4 cil. clutch fluid has to be replenished everyday but it is loosing it while driving because it is not leaking while parked. we ...

clutch was having a hard time going into gear.All of a sudden there was a high pitched squeal/scream coming from the transmission area. The clutch was having a hard time going into gear. Grinding, had

...hard when running turn car off it goes in easy probably just a clutch adj. or problem. gone unfixed can destroy the trans synchronizers I would lean towards clutch h hydraulic failure or leaks. Che k ...

...clutch pedal to see if it engage,if not,you must have to bleed it ,it should be a bleeding valve at the slave cilinder,you will need assistance to do this ,to pump the cluth pedal several times and ...

clutch pedal in hard to keep running/ Any ideas? thrust bearings are bad and the flywheel is moving out of range of the crankshaft sensor, or the crankshaft sensor is sitting too close to the flywheel