1999 Isuzu Rodeo "remove 4 bolts hub assembly" Questions

Ad

Question about Isuzu Rodeo

1 Answer

...4 bolts? my truck is a 99 isuzu rodeo LS 4wd remove inner cv boot, just on inside edge is circlip which holds inner bearing joint into outer housing remove circlip and separate joint outer housing ...

Ad

Remove the 4 hub retaining bolts. NOTE If the hub is difficult to remove, install 2 long bolt in the bolt holes and strike them to loosen the hub. the spec on bolt torque is huge, do not GUESS !!! log

Ad

...Remove the 4 bolts retaining the hub unit to the steering knuckle and remove the hub unit. Remove the 4 bolts retaining the hub unit to the steering knuckle and remove the hub unit/rotor assembly ...

...if equipped. Back off the hub/bearing mounting bolts 1/4 inch each. Then tap the bolts with a hammer to loosen the hub/bearing mounting bolts. Remove the bolts and remove the hub/bearing

Question about Isuzu Rodeo

1 Answer

...4 Wheel Drive) To Remove: Raise and support the vehicle Remove or disconnect the following: Tire and wheel assembly Rotor (See: Disc Brake Rotor) Wheel speed sensor and brake hose mounting bracket ...

Question about Isuzu Rodeo

1 Answer

...Remove 4 axle hub mounting bolts. Special tool 09432-11000 (Typical) Using tool 09432-11000 (or suitable gear puller), remove tone wheel. Remove carrier. Remove stakes and remove flange nut. Support ...

...Remove the 4 bolts retaining the hub unit to the steering knuckle and remove the hub unit. Fig. 4: Remove the 4 bolts retaining the hub unit to the steering knuckle and remove the hub unit/rotor ...

...4 Remove the brake caliper mounting bolts and carefully remove the caliper (along with the brake pads) from the rotor. Do not disconnect the brake line. 5 Secure the caliper out of the way with the ...

...4. Remove wheel bearing with suitable tool. • Do not remove dust cover unless necessary. • Do not reuse dust cover if removed. 5. Mark relative positions of dust cover and knuckle for proper ...

...remove these 4 bolts then anything still holding the hub in place will be rust and dirt.  Remove hub, check the knuckle for cracks or damge and replace if there is any.  Otherwise if it ...

Not finding what you are looking for?
1999 Isuzu Rodeo Logo

1,180 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Isuzu Rodeo
2001 Isuzu Rodeo

832 Questions

2000 Isuzu Rodeo
2000 Isuzu Rodeo

819 Questions

1998 Isuzu Rodeo
1998 Isuzu Rodeo

720 Questions

1995 Isuzu Rodeo
1995 Isuzu Rodeo

623 Questions

1997 Isuzu Rodeo
1997 Isuzu Rodeo

547 Questions

Top Isuzu Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...