2002 Chrysler PT Cruiser "brake light" Questions

brake lights don't work brake lights are out Here's a link to your stoplight switch,it's attached to the brake pedal,could just need adjusting,when brake pedal is pushed switch is released turning

brake light on b4 brake job? and did you do the brake job or a shop.....if the abs light wasnt on b4 brake job thenwhen the pistons on the caliper where pushed back it screwed the abs pump...if it was

...brake light switch 3 times--brake lights work for about a week--ideas? I would like to know if you have turn signals working in the rear. These are the same bulbs that brake lights use. If you don't ...

is there a fuse box on the pt so i can change the brake lights the brake lights are out If none of the brake lights are working than checking the fuse would be a good start. The owners manual will ...

...light and brake light on; brakes locking/overheating, but brakes seem good, had just applied new brakes/rotors and flushed brake fluid lines Car has only 30,000 miles. Well cared for. Master cylinder ...

...brake light, it appears to be the same bulb as the plain old rear light (which goes on when headlights are turned on) which works fine--looks as if it has two sets of filaments. Is this correct? Both ...

Brake light How do I change thrid brake light Access to the brake light bulb is through the tail light lens. First, remove the tail light lens by removing the single star shaped screw that secures the

...Brake Light I have a 2006 PT Cruiser. I need to change th light bulb in my brake light. Can I just change the bulb or do I have to buy a new entire rear light? The bulb in the rear light has burned ...

...brake light on. Something gets hot on drivers side wheel have seen smoke smells like something electral Check the brake fluid level. If the level is low the brake light will come on. If the brake ...

...brake light switch is usually, if not always, mounted on the brake pedal. You will have to look up under the dash at the upper end of the pedal. See if you can fit the box back onto the pedal. There ...