2002 Chrysler 300M "jerking running gas rpm" Questions

jerking and engine knock at high RPM I have noticed lately that my car is a little sluggish at times. The car runs really sluggish on acceleration and spurts/jerks a little around 2.5k-3k RPM. It also

car jerks when i let off the gas car jerks and rpm gauge jerks when i let off the gas then runs smoothly check out the throttle position sensor.

...jerking motion when I reach the 4000 RPM mark. I press the gas pedal down further and it just continues to **** and won't kick out. The check engine light is on and my mechanic advised me that his ...

...jerking loses power and engine rpm will not go above 2000. Turn off engine let set for couple of minutes and it starts and runs fine. May repeat, but may not fo Tahoe can be running absolutely fine, ...

...RPM my car starts to lag and jerk. If I release the gas then slowly apply it again I can accelerate to roughly 80 MPH. The transmission shifts normally as long as I keep the RPM below 3K. I have put ...

...rpm. If I get off the gas and re-accelerate, or if I hit the gas harder, it settles down. try putting some fuel injector cleaner in the gas I have a 2007 Chevy equinox it seems to jump and jerk when ...

jerking This problem comes and goes? Sometimes the car will start running really rough, such as at a stop light, put it into first and go to take off. The car starts jerking, and the rpms go up. (4000

...GAS, WHEN IT IDLES UP TO 2 RPM THE CAR WILL **** HARD AND DROP TO 1 RPM. I HAVE A 99 OLD INTRIGUE GLS. AFTER IT DOES THAT, THE CAR WILL DRIVE FINE. THIS HAPPENS ABOUT EVERY 2 MONTHS BUT THEN AFTER I ...

...gas near empty, slowing down speeding up.... Had same problem: cutting out at low rpm, jerking, a huge clunk or shudder at higher speed (like transmission was going out), and rough idle. All these ...

...gas and rpm obove 800 rpm car does not stall,sometimes driving the tach drops to 0 the car jerks stalls for a second and takes off replace the idle control sensor to get an idle speed above 800 run ...