2000 Acura TL "ball whacks" Questions

ball joint out with a hammer, don't hit the stud or you'll never get the nut back on. Two bolts on the brake calliper. once you have all that off give the end of the axle a few whacks until it's free.

trying to remove a lower ball joint on a 2000 ford expedition four wheel drive. how do you get the lower ball joint out of a frame? If not bolts holding then they usually need to be pressed out & In. ...

...rotor). I'd make that the first task to undertake because your next task will be to remove lower ball joint. After you get that spindle nut loose, take a hammer, 32 oz. preferrably and whack area ...

CV joint replacement CV joints are popping and need to be replaced. I can't free the lower ball joint from the axle housing assembly so it can be swung aside to allow removal and replacement of the CV

...ball joint removal tool at any parts store, just looks like a big fork. but i prefer to hit the control arm with a hammer, a few good whacks will bring it right out. whatever you do, don't hit the ...

i'm trying to replace the idler arm and having a hard time seperating the ball joint. i'm using a pickle fork and a air chisel with a pickle fork in it ant ideas thanks lou Make sure the jack is under

Ball Bearings Damaged on 2002 Kia Rio The back tire locked up on our Kia Rio and we noticed the wheel drum was damaged. Upon removing more to see if the calipers were sticking or damaged we noticed ...

...whacks with a hammer should pop the joint out. Clean the hole out lightly, just to remove loose rust and dirt. Put the ball joint, minus the grease fitting ,,in the hole and use the jack with a block ...

...when done the toe out/in will need to be reset. the hardest part of the job will be removing the ball stud from the knuckle. i remove the nut from the ball stud then whack it good on the knuckle ...

...whacks. Then you need a ball joint removal kit to R&R the ball joint. You can rent these at parts stores with a deposit. (You get your money back). Check them with the parts guy first. If ...