2006 Jeep Grand Cherokee "engines revs" Questions

Engine starts and idles fine, but will not rev up (2001 Jeep Grand Cherokee 3.1 diesel auto) Has run fine for some time, well serviced etc. When problem came on car was being driven fine when suddenly

my grang cherokee2002 us spec, while driving trnz changes fine but when cick down or full excelrate and RPM reaches 4.5 or 5 engine is loosing power and getting noisy and RPM not going more, while ...

grand cherokee 4.7 v8 with lpg conversion (done feb 2010 ) engine has started to run lumpy and is down on power, when ticking over revs go up and down from between 5000 revs up to 13000 revs every few

2004 jeep grand cherokee idling problem. Revs motor 200 to 500 rpms higher while driving. My jeep grand cherokee tends to idle high in park. It should be at 500rpm but it is at 1000rpm. Also, while ...

ENGINE DIES When starting you have to rev eng. to 3000 rpm's or it just dies. It will idle if u do the rev eng bit ! Check for a vaccum leak at the intake with starting fluid. Frankster016

not much heat if fan is on high, better heat on 2nd speed, rev engine to 4000rpm very good heat on high, Replaced thermostat, replaced water pump,same problem, waiting for gasket to dry before I rev ...

fuel sensor when u rev up engine jeep cuts off are u revving engine in park?....some of these have an R.P.M. restrictor that protects engine damage due to high R.P.M. without load on engine (such as ...

Valve/tappets?? heard a horrible tapping noise comming from engine earleir..driving through poland, germany and france back to uk..so pluued into hotel for night down the road from a jeep ...

What exactly is transmission slippage? I am not real good on car lingo and have always been a little confused by what this meant. My understanding is the you hit the gas and the engine revs but car ...

my jeep CRD 2.7 started to misfire at low revs in the mornings but seemed ok when warm. the injector on cylinder 1 then started to leak and it went into limp mode, this was repaired.A few weeks later ...