2006 Jeep Grand Cherokee "changing mass flow sensor" Questions

my battery went dead in my jeep,after changing the battery it dosnt want to idle right it might be a idle air control vavle or air flow mass sensor map sensor it could be alot but try that

mass air flow sensor--replaced it...that was it...it's easy to replace---like changing a bulb, but it's relatively expensive... btw, if you plan on keeping your 4runner, plan on replacing the radiator

...mass air flow sensor and the fuel pump, 2000 grand cherokee. Have your fuel pressure checked. It may be a bad regulator. Try cleaning the throttlebody and air filter. Check your spark plugs, coil and ...

...mass air flow?. I think your computer is fine it could be have a loose ground issues but computers dont go bad. p1296 Loss of Voltage can be the Throttle pos sensor, But majority of cause is the 02 ...

Mass Flow sensor as well. All 3 sensors on the throttle body have been replaced. I've had an oil change, spark plugs replaced, air filter, I've even applied sea foam to the gas tank...

...changing the fluid and filter every 30,000 miles. It could be something else too the transmission shifting is controled by the computer. The computer gathers information from various sensors on the ...

...mass air flow sensor and the manifold pressure sensor (MAP). Instructions for testing are too long for me to write them out, but can be found in any decent repair manual. As a last resort, you can ...

...Mass Air Flow sensor MAF and your carborator/throttle body). 1st Visually inspect those hoses and then spray some carb cleaner on these parts too and listen for the engine to rev up a tad. If it revs ...

Mass Airflow Sensor (MAF) that might be failing/malfunctioning. Some vehicles use these instead of the Manifold Absolute Pressure (MAP) Sensor, which you may have. These sensors need to be checked and

...mass air flow sensor. The oil then congreates on the sensor wires, and throws a P0171 fuel trim code because the wires are no longer reading the proper air velocity. I clean the sensor, reset the ...