2006 Jeep Grand Cherokee "change throttle control sensor" Questions

Ad

...inch lbs.) torque. Manually operate throttle control lever by hand to check for any binding of TPS. Connect TPS electrical connector to TPS. Install air duct/air box to throttle body. Hope this ...

Ad

Question about Jeep Grand Cherokee

1 Answer

...throttle body cleaner spray. I changed the Idle Air Control Valve (idle speed motor) which was very clogged. While I had the throttle body off I also changed the Map Sensor and Throttle Position ...

Ad

Question about Jeep Grand Cherokee

1 Answer

...throttle body cleaner spray. I changed the Idle Air Control Valve (idle speed motor) which was very clogged. While I had the throttle body off I also changed the Map Sensor and Throttle Position ...

...control valve and throttle position sensor. Control valves can get gummed up. Control valves can usually be cleaned out by spraying carb cleaner into the passage in the throttle body bore. In severe ...

Question about Jeep Grand Cherokee

1 Answer

change. The ones to look at is the tps sensor( throttle position ) and the isc( idle speed control) if the isc motor is stuck open or shorted it will cause this.Make sure throttle cable isn't bound up

...throttle down hard it's surges forward and when it's supposed to change gear it just starts to kangaroo unroll you lift off. sometimes the red light warning of the electronic throttle control ...

...throttle body have been replaced. I've had an oil change, spark plugs replaced, air filter, I've even applied sea foam to the gas tank..... Still, a big fat Nothing! Please HELP, I ...

...throttle position sensor, also check the idle control valve...Don't just buy stuff...do testing first. Had similar trouble with a 1998 TJ 4.0. replaced plugs, wires, cap, rotor, fuel pump. An engine ...

Question about Jeep Grand Cherokee

1 Answer

All timing and fuel mixture is controlled by the engine computer. Main inputs to the computer that influence changes are the throttle position sensor and MAP sensor but all sensor inputs are evaluated

Question about Jeep Grand Cherokee

2 Answers

...change the sync signal to the Powertrain Control Module (PCM) and cause a stall situation.Also you should have someone load test the battery and check the cables for corrosion. If the battery drops ...

Not finding what you are looking for?
2006 Jeep Grand Cherokee Logo

958 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...