2003 Jeep Liberty "wait put antifreeze car" Questions

...Put the fuel in a glass jar and wait a day if necessary to see if the fuel separates. Bad fuel would also account for a rough idle and the smell. The newer fuels we have today can separate and also ...

...wait before putting antifreeze in car after driving Just long enough for car to cool sufficiently so you don't burn your fingers or get splashed in face by steam when removing radiator cap. 10-15 ...

...put in a 1997 toyota 4runner 3.4 liter ? 50/50 with water.v6 capacity is 2.5 gallons. make sure your antifreeze is not already premixed 50/50 with water if it is just our it in. if its strait ...

wait for the thermostat to open. Add antifreeze to keep the radiator full. Look for air bubbles or lots of foaming in the coolant. That would indicate a blown head gasket and the reason you are losing

Wait until the car engine is cold and drain the antifreeze out of the car and then remove the hose and replace it. Be sure the clamp for the hose is properly located, you can look at where they are on

...Wait till it warms up then as soon as it bubbles over at the Allen head spot put the cap back on. Wear some gloves good possibility you will get burnt. Make sure that coolant in the reservoir is not ...

FROM GETTING SCALDED.BUT WAIT UNTIL ENGINE COOLS AND PUT 50/50 WATER AND ANTIFREEZE MIXTURE.BECAUSE HOT WEATHER HOT ENGINE WILL EVAPORATE WATER.ADD COOLANT RAISE BOILING POINT TO KEEP FROM EVAPORATION

...PUT RADIATOR CAP ON LET ENGINE IDLE WATCH TEMPERATURE GAUGE THEM TEMPERATURE GAUGE START RISING. TURN OFF ENGINE WAIT A WHILE. USE A LARGE RAG PLACE IT OVER THE RADIATOR CAP THEN SLOWLY OPEN RADIATOR ...

how do you put water in a 2003 oldsmobile Alero wait until engine cools add 50/50 antifreeze mix only fill up to line on side of resivoir where it says min max on over flow tank dont over flow

...wait 10 or 15 min and she goes again after I puts gas line antifreeze in her I changed the fuel filter Change crankshaft sensor. I just dealt with the same problem.. .... camshaft positioning