windows are not going down need to find out if power is being ran to the switches check fuses and see if the switch is powered thru a relay switch
check to make sure the fuse is good ,then find out if you are getting power to the master switch in the drivers door,if you are getting power to the switch and they are still you can jump power across
...Check for power and ground at the motor (with switch up and down, powers and ground will reverse). If you have power and ground, at the motor, you probably have a faulty motor. If you don't, then ...
...power from the master control switch on the drivers door. Drivers door window gets used the most so it could be the motor, window switch, relay or fuse. Could also be a broken wire in the rubber boot ...
...power windows and rear window will not operate. Check fuses and relays both are fine? You have bad connection in either the harness that runs between the door and body of the jeep or there is a loose ...
...window Check the wiring harness that runs between the door and body of the Jeep. It is visible when the door is opened. There may be a bad connection in this area or inside the door at the switch ...
...power mirror on passenger side. The driver side works fine. I have replaced the main switches in driver door,tried a body control module,and checked the wires where they go thru the door and body. ...
...power window on passenger side wont work.Can hear clicking noise from door when using switch.How can I open door panel Check this documents, in spanish, but you can find graphics to help in there: - ...
...check for power at the switch if no power is present then proceed to the rubber boot it should simply be squeezed and will pull out at each end check for power between the two points you will need to ...
3,397 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions