2000 Jeep Wrangler "doesnt heater fan switch" Questions

doesnt burn up the compressor. If your blower motor is not operating, you may have a fuse blown that needs to be replaced, or the control chip that plugs into the blower motor (for fan speed settings)

heater there is heat but it doesnt blow out it used to start blowing if i hit the dash board area hard enough now it doesnt work at all got the car from my older brother everything ran great until the

...heater, all looked good though. yet fan doesnt work where is it located and how do you test it? According to my wiring diagram, the blue and white wire from the blower motor gets power from the key ...

heater blower doesnt work on 2005 chrysler 300 heater blower doesnt work on 2005 chrysler 300 Locate the fuse pannel and check for blown fuse...If fuse not blown - check fan control relay for proper ...

...heater or ac either the fan motor is bad or the fan resistor. get a test lite and unplug the fan motor probe the hot side of the plug while turning on the fan switch if it lites up the fan is bad if ...

...try changing your thermostat first if that doesnt work flush your system it could be clogged and then if that doesnt work it is pointing to your heater core and it might have to be ...

...switch, fan works but not when on the car, also doesnt overheat when heaters on inside car. replace your relay for your radiator fan or check fuse check for a feed to the radiator switch fan ?? ...

...doesnt turn on, is it just the fan switch on the heater a/c control box? Usually what happens is the switch goes bad and starts sending multiple current paths to the resistor. Then the resistor pack ...

...doesnt work Nothing happens when you turn on the heater/ac. No sound, nothing. I checked the heater/ac fuse in the fuse box but it is fine. I see a black plug that says HEATER on it but nothing is ...

I have a 2001 jeep wrangler sprot. The heater/AC fan switch will work for fan speed 1 through 3 but fan speed doesnt work at fan speed 4 Replace the blower motor resistance it controls the fan speeds.