2006 Ford Focus "egr valve" Questions

...EGR valve, an actuator solenoid, and a differential pressure sensor EGR (DPFE). These things work together to deliver the correct amount of recirculation based on engine temperature, load, etc. The ...

...egr valve was bad and needed to be replaced .. I replaced it and it lasted about a week and had the same problems .. when I replaced the egr valve I did not replace the gastket ... how important is ...

...pressure) sensor is faulty and needs to be replaced There is a blockage in the EGR (most likely carbon buildup) The EGR valve is faulty The EGR valve may not be opening due to a lack of ...

...EGR valve as 2002 Ford Focus- Where do I find the EGR valve as I am looking at the engine? In the engine bay you will see what looks like a flying saucer. That is the egr valve. Should have a small ...

egr valve should it b left open or closed?my cars idlin bad an dont want to go,it dies at lights an stop signs that sounds more like idler control valve, but the egr is in close position all the time,

...EGR valve by pulling the vacuum hose off the top, and blocking the hose. The idle didn't smooth out. I applied a vacuum to the EGR valve manually and the car immediately stalled which tells me that ...

where do i find the egr valve on a ford focus 1.8 petrol and can you describe it egr valves are normally fitted to diesel spec are you sure its not a diesel?

egr valve It could be a broken egr tube that comes of the exhaust manifold to the egr valve .More info needed Hi, My guess is that you have a hole in your muffler pipe some where. Have it checked out

finding where the EGR vacuum solenoid is located First locate the EGR Valve. Then trace the attached vacuum line, it should be connect to the EGR Vent Solenoid.

...(PCM), the probable cause is a sticky exhaust gas recirculation (EGR) valve. To rectify this concern, a new EGR valve with a stronger EGR valve motor and revised PCM calibration should be