1998 Nissan Maxima "replace knock sensor grand" Questions

...replace these parts, would like to do it myself if possible but can't locate them on my engine or pipe. Do I need special tools to do this? gpk722000: the knock sensor is located under the intake ...

...knock sensor code...knock sensor replaced... reset computer ....knock sensor code back. car has 120k so I replaced for and aft O2 sensors ....and the coil pack ......knock sensor code returns ...

...knock sensor has gone bad (bank 2) it's in between the engine and transmission, is it possible to replace it without removing the transmission? What code did you pull ? How do you know it's bad ? ...

...replace the knock sensor: Disconnect the knock sensor wiring connector. Then, unscrew the sensor. Remove the knock sensor. Reverse the procedures to install the part. A defective knock sensor may ...

...knock sensor on a 2013 Jeep Grand Cherokee lerado 3.7 ,and how much to repair it The two knock sensors are bolted into the cylinder block under the intake manifold. The two sensors share a common ...

replace the following, Fuel Injectors, Coils and Wires, Crankshaft sensor and the crankshaft balancer. It will not rev up past 2000. Need help solving this problem please. po330 is a bad knock sensor,

Replace the knock sensor Hope this helps Steve Bad "knock sensor" Your 1993 OBD1 system does not have a "p" numerical code, any code that starts with a "p" is an OBD2 system, and OBD2 did not come out

...knock sensor was changed between the 98-99 model yrs. my question is how can i hook my 99 knock sensor up to the 97 motor As long as you can get it bolted to the engine somewhere it should work OK. I ...

...knock sensor but i replaced it and it is still saying the same thing. sometimes it stalls when u start to go again from a stop but it so far starts right up . Any suggestions ??? How loud is your ...

knock sensor should come pre-coated with sealant/threadlock, just install it and tighten by hand until snug. 5. Torque the sensor to 14 ft lbs. 6. Replace the electrical connector. 7. You should flush