2004 Ford Focus "belt connected alternator" Questions

alternator Remove the drive belt NOTE: Some models use a belt tensioner that applies tension to the drive belt. The best tool to use for this job is the serpentine belt too. If you can borrow one from

alternator Remove the drive belt NOTE: Some models use a belt tensioner that applies tension to the drive belt. The best tool to use for this job is the serpentine belt too. If you can borrow one from

belt from the alternator pulley. Release the two air intake tube retainers and remove the air intake tube assembly. Remove and discard the generator B+ cable nut and disconnect the B+ cable. Remove or

...belt off the Alternator pulley. 6. Loosen the alternator Pivot bolt and the bolt that attaches the alternator to the adjustment arm If you vehicle does not have a belt tensioner: 4. Loosen the ...

Try to get to ur nearest garage to check on that probs. Tah! Your alternator belt may not be tighten enough. Turn off your engine, press the belt with your thumb, it must have à 0.5 " depression

Belt on as a pair this time. This will insure the tightest fit possible. As long as you put in a 12 Volt battery connected to the correct terminals, there is little you could do wrong with the battery

...alternator on my 2005 ford focus 2.0 automatic You need to disconnect the negative cable on the battery, then remove the drive belt, now remove the alt. attaching bolts. Raise the vehicle and remove ...

belt and/or a charging system problem. check all wires to battery from alternator. make sure you have proper power from alternator to battery. with engine running voltage to battery should be about 14

belt(s) and the alternator, a simple test of the alternator is to have the car running (in park of course) and disconnect the power cable from the battery, if the car runs the alternator will be ok if

...the belt. Get the replacement starter and installation is a reverse of the removal., here is a pretty good write up on another site ...