2004 Ford Focus "abs light stays changing bearing" Questions

abs light stays on on my ford focus my abs light stays on on my ford focus when the ABS light stays on it means there is a fault present in the ABS system and the ABS has been disabled, as long as the

ABS light is staying on. manually, the brakes work however they shimmy.changed the brake pads,checked the brake fluid and ABS fuse,bud when changing the pads,did now clean the wheel sensors.could this

abs and brake light stay on just changed the right front wheel bearing on my 2004 dodge ram standerd cab 2 wheel drive now my abs and brake light stay on is there something im missing made sure abs ...

abs and traction control light stay on resently, i had my brakes, rotors, and bearings changed in my car. Every since then, my abs and traction control light stay on.I also have a grinding noise now. ...

...abs sensor is built into hub[bearing]common problem when changing them and or brakes r that the sensor connection is not properly reconnected or wire got damaged recheck the sensor wiring and that ...

ABS light stays on i just replaced my rotors and pads on my 03 f150 and my abs light wont shut off. i just recently changed my driver wheel bearing as well which is were the wire for my abs is located

...slip light stays on and wont come off what do i do Make sure you plugged in the ABS sensor wires into the hub alot of times you will end up changing those too when you do a wheel bearing

ABS light comes on intermittently. When the ABS light is on the power windows and blower motor do not work. When the ABS light is off everything works just fine. Help???? That sounds strange about the

...changed the passenger side wheel bearing and now the ABS and brake warning light are staying on? Replace the speed sensor, if it is in the bearing you just replace then you will have to replace

...abs sensor connected to the wheel bearing itself. Its a wire going right into the bearing which is sometimes visible. Over time the bearings get a little play in them and causes the sensor to read ...