Question about Cars & Trucks
...install the clutch plate correctly? If you put it in backwards, the pressure plate will not be able to move far enough to release it. If the clutch plate is in correctly, you need to check if the ...
...install in either direction. Some clutch discs are made so that the inner hub with springs, can be installed towards the crankshaft, or towards the tranny. There can be a handful of reasons. First, ...
...clutch release arm/shaft. If this worked correctly before the new parts were put in, the person(s) that did the work should be responsible for getting it to work again. Make sure that you don't have ...
...clutch arm and see if you can move it or if when you remove it does it goes back further with the spring i.e. not seated with the linkage in place...? (you should feel the spring action of the clutch ...
...release problems. tried better brand clutch same thing. No bleeder in hydraulic system. bench bled entire system and installed as one unit. Clutch arm moves only one half of an inch no matter what I ...
...clutch release mechanism problem, adjustment or one of the above. Is the release arm not bent or cracked and has bent since assembly? Have you got the correct thrust bearing and has it not perhaps ...
...Release the clutch pedal position switch (CPP) (11A152) from the orientation clip. Remove the plastic retainer. Push the lock tabs together. Slide the plastic retainer off the clutch pedal position ...
...clutch slave cylinder, then remove the 14mm nut tha holds the fork arm, then you can remove the trans, however reassembly is a whole nother complicated story. How does one install rhe fork on the ...
Question about Cars & Trucks
...release the clutch plate for gear selection I suspect that your movement will be exceeding 3/4" thereby over loading the spring action That is the area I would be investigating Maybe the kit you have ...
clutch release spring in my 1990 acura integra. when ****** is off of the car i can lift the clutch arm all the way up and it snaps back down normally from the new spring and throwout bearing move out
3,503 questions posted
Usually answered in minutes!
2,348 Questions
2,120 Questions
1,869 Questions
1,431 Questions
1,365 Questions