...install a new crush sleeve if you do it by the book, I have found that if the yoke is removed a new seal installed and the yoke tightened to about 50 foot lbs of torque it is ok, as far as the lube ...
...crush sleeve between the two bearings that if tightened too much can cause too much pre-load causing premature bearing failure. It is also recommended to replace the pinion nut with a new one every ...
...crush sleeve the seal an add a speedy sleeve to the york and re-rest the depth of the third member gear and replace oil so yep pretty much he ill have to come close to rebuilding it. The pinion gear ...
Question about Ford Cars & Trucks
...crush sleeve on the pinion shaft and install the pinion nut. Tighten the pinion nut to the specified torque using a torque wrench. The torque specifications for the pinion nut will vary depending on ...
cleaner and put some blue lock tight on the thread. Install the yoke and the new nut using care not to crush the sleave anymore but, at the same time make sure it's tight. I hope this helps, good luck
Question about Ford Explorer
...too tight. 185-210 ft. lbs, if you are only changing a pinion seal. If it's a rebuild, there is a sequence you must follow to properly compress the crush sleeve. Use red locktite on the ...
...crush sleeve that needs replaced. Proper installation of this sleeve is critical for noise free operation. If the pinion nut is loosened at any time during the adjustment process then a new sleeve ...
...crush sleeves are measure in inch pounds. With these you are measuring the drag on the pinion gear with out the differential installed yet. Usually between 15 and 30 inch pounds. I try to set them at ...
...crush sleeve i am not aware of a specific torque spec , you have to crush the sleeve until the end play of the pinion measured with a dial indicator matches the proper spec wich should have come with ...
Question about Ford Explorer
install carriers bearing and pining gear on jeep commander Just like any other 3rd member. If you do not know what you are doing, I would not suggest doing the job yourself. You need to have a certain
1,541 questions posted
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions