blend door. Vacuum control motors are used on both air distribution and air inlet doors. The air inlet and panel/defrost doors use a two position vacuum control motor. The floor duct/panel door uses a
...to get at it. Then the ducting is ...
air plenum from inside the dash to gain access to the blend door. NO MATTER WHAT, FIX THE F-15O and -AS OFTEN AS POSSIBLE - crush PT CRUISERS, [they are TRUE road hazards].Now this may not sound
Question about Ford F-150
...air except the two driver side vents. I've read forums to try to diagnose, vould be upper blend acuator or the climate control unit. After reading so many posts, I am not convinced it is the ...
...perfect. your problem is caused by the air temperature control blend door actuator motor being defective, the little motor moves the door that gives either hot air or cold air or a blend of the
temperature blender actuator fuse which fuse is the temperature blender actuator fuse There is not a seperate fuse for the air temperature control blend door actuator motor.
...AIR IS STILL HOT sounds like your blend door actuator has failed, or the lost vacuum to this actuator, or something got into the vents holding the blend door into position. Most common is the acuator ...
...IS THE SWITCH THAT CHANGES COLD TO HOT AIR BLOWING You are referring to the blend door actuator which is accessed by removeing the black plastic trim piece at the transmission tunnel under the ...
...air 2. the thermostat for your cooling system is bad 3. the link to adjust the temperature is too short (did you feel the switch loose when changing temperature from hot to cold)? hope this helps. ...
...air conditioner The temperature blend door actuator itself is not repairable....it will have to be replaced. Its located under the center dash and is screwed to the heater box. I have included a ...
231 questions posted
Usually answered in minutes!
2,636 Questions
1,214 Questions
1,298 Questions
1,160 Questions
1,038 Questions
