1966 Ford Mustang "power steering control valve" Questions

...power steering control valve and ram were leaking I bought a rebuild kit for both of them when i reinstalled them and turned the motor over the steering wheel rotates violently hard to the right at ...

power steering on my 1966 Mustang 6 cly I got off ebay. When I finished and started the engine the steering wheel jumped back and forth rapidly out of control. I have found a fluid leak where the line

...Power Steering I need a little bit of advice. My 1966 Mustang 289 Has power steering and it seens to work fine until it is hot (After 1HR) Then it gets a bit firm , still working just a little ...

...power steering went in and out after warm up, lost power steering at low speeds, returns as you increase speed. Replaced control valve and hose. Pump was replaced two months ago. After pump ...

power steering control valve leeks. The ball moves from side to side. Can it be rebuild and where can I get parts? i would advise against any attempt to take it apart. the best way is to replace it as

control valve and re-sealed the power cylinder, now the vehicle steers itselt to the right. Any suggestions, could it be that the p/s system isn't bleed properly? control valve out of adjustment. yeah

...power steering problem replaced two pumps already still no power assist , replaced control valve, now have power assist only when revving up past 3000 rpm, or driving fast. there may be air traped in ...

...power steering problem I have totally restored this car doing most of the work myself. I installed all new steering parts except I had to use rebuilt parts for the PS control valve and the hydrolic ...

how to rebuilt 1965 ford mustang power steering control valve If you have a fax number I will send you the procedure from the shop manual

...POWER STEERING CONTROL VALVE POWER STEERING WORKED GOOD BEFORE I REBUILT THE CONTROL VALVE. THE BALL AND CUPS WERE WORN. NOW IT PULLS RIGHT. I HAVE A REPAIR MANUEL AND EVERYTHING IS PUT BACK RIGHT. ...